Publicité
Les langues disponibles
Les langues disponibles
Trouble or fault
The tool or battery gets very
hot.
Not paired.
Invalid entry.
The command is not possi-
ble; no reaction.
Surveillance mode is active.
Sleep mode is active.
Low battery in the rotating
laser.
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
*2134493*
Possible cause
Electrical fault.
The devices are not paired.
Invalid entry; the command is not
possible.
Valid entry, but the tool doesn't
react.
Surveillance mode is active. Re-
alignment not possible.
The tool is in sleep mode.
Low battery in the rotating laser.
2134493
Action to be taken
▶ Switch the tool off immediately,
remove the battery, keep it
under observation, allow it to
cool down and contact Hilti
Service.
▶ Pair the rotating laser and the
laser receiver. → page 14
▶ Make a valid entry again. Read
the operating instructions.
▶ Check that all devices are
switched on.
▶ Check that all devices are within
direct range.
▶ Repeat the entry.
▶ Check the positions of the
rotating laser and the PRA 30
laser receiver.
▶ Check that all devices are within
direct range.
▶ Restart automatic alignment.
▶ Activate / deactivate sleep
mode. → page 13
▶ Charge the battery.
English
19
Publicité
