Adjusting Stabilizer - RIDGID 920 Roll Groover Mode D'emploi

920 Roll Groover
1 / °
2
Figure 10 – Offset Away From Operator

Adjusting Stabilizer

NOTE! The stabilizer has two different positions. The
position closest to the drive shaft will allow the
stabilizer to work for 2" - 16" pipe. The second
stabilizer position will work for 14" - 24" pipe.
1. Remove the two 3 / " bolt that hold the stabilizer in
8
place ( 9 / wrench or socket) (Figure 11) .
16
10
Figure 11 – Removing Bolts Holding Stabilizer
2. Move the stabilizer into the desired position (Figure
12).
Figure 12A – 2" - 16" Position
Figure 12B – 14" - 24" Position
Ridge Tool Company