Stanley STHT1-77032 Mode D'emploi page 5

6.
View the Volume measurement at the bottom of the
display window (Figure E #3).
Changing the Unit of Measure
Once the current measurement is taken (the device is not
in Continuous Measure mode), you can change the unit of
measure from decimal ft (6.21 ft) to fractional ft (6'02"
fractional ft to meters (1.894 m), meters to inches (74
in), or inches to decimal ft.
Press and hold until you see the measurement
change (2-3 seconds).
Turning Off the Tool
The tool can be turned off in either of these ways:
• Press and hold for several seconds (until the
display window clears).
• If you do not use the tool for 120 seconds, it will
automatically turn off.
Warranty
STANLEY warrants this product for a period of Two (2)
years against deficiencies in material and workmanship.
This LIMITED WARRANTY does not cover products that
are improperly used, abused, altered, or repaired. Please
call 866-786-5924 for more information or return instructions.
Unless otherwise noted, STANLEY will repair without cost, any
STANLEY product found to be defective, including parts and
labor charges, or at STANLEY's option, will replace such tools
or refund the purchase price, less the amount for depreciation,
in exchange for the defective tool. THIS LIMITED WARRANTY
EXCLUDES ALL INCIDENTAL OR CONSEQUENTIAL
DAMAGES. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so these
limitations may not apply to you. This TWO YEAR LIMITED
WARRANTY gives you specific legal rights that may vary from
state to state. In addition to the warranty, STANLEY Lasers
are covered by: 30-Day Money Back Guarantee. If you are not
completely satisfied with the performance of your STANLEY
Laser for any reason, you can return it within 30 days from the
date of purchase with a receipt for a full refund.
IMPORTANT NOTE: The customer is responsible for the
correct use and care of the instrument. Moreover, the
customer is completely responsible for periodically checking
the accuracy of the laser unit, and therefore for the calibration
of the instrument.
Calibration and care are not covered by warranty.
),
9/16
9/16
GB
5