Special attention is to be paid to the metal anti-grease ﬁlters. In fact, frequent cleaning of the ﬁlters and their supports helps ensure that no grease

accumulates on the hood, which is dangerous and can cause ﬁres.

EXTERNAL CLEANING

You are advised to clean the external surfaces of the hood at least once every 15 days to prevent oily substances and grease from sticking to them.

Do not use too much water next to the push button control panel and lighting devices in order to prevent humidity from reach-

ing electronic parts.

You must not use detergents containing abrasive, acid or corrosive substances or abrasive cloths: a direct consequence of not

complying with these warnings will result in irreversible deterioration of the hood's surface.

The Manufacturer declines all responsibility for failure to comply with these instructions.

CLEANING THE BRUSHED STAINLESS STEEL HOOD VERSION

To clean the brushed stainless steel hood, the Manufacturer recommends using "Magic Steel" wipes. Alternatively, it can be cleaned using a damp

cloth, slightly moistened with neutral, liquid detergent or denatured alcohol. Finish oﬀ cleaning by rinsing well and drying with soft cloths.

CLEANING THE WHITE FINISH STEEL HOOD

To clean the hood, use water and neutral soap and a soft cloth.

Finish oﬀ cleaning by rinsing well and drying with soft cloths.

CLEANING OF INTERNAL PARTS

It is forbidden to clean electrical parts, or parts related to the motor inside the hood, with liquids or solvents.

Do not use abrasive products.

All these operations are to be carried out after having disconnected the equipment from the electrical mains power supply.

METAL ANTI-GREASE FILTERS

The metal anti-grease ﬁlters are there to contain suspended grease particles: deposited on the ﬁlters, these feed on any

ﬂames released when cooking, generate unpleasant odours, and compromise the passage of air, thus reducing suction

performance of the hood.

For this reason, it is advised to frequently wash the metal ﬁlters (at least once a month) leaving them to soak in boiling

water and dish washing liquid for 1 hour, taking care not to bend them. Do not use corrosive, acid or alkaline detergents.

Rinse them well and wait for them to be completely dry before reassembling them.

Washing in a dishwasher is permitted, however, it may cause the ﬁlter material to darken: to reduce the possibility of this

problem from happening, use low-temperature washes (55°C max.).

Open the external suction panel to remove the metal anti-grease ﬁlters (refer to the instructions

(refer to the instructions

DISPOSAL AFTER END OF USEFUL LIFE

The crossed-out wheeled bin symbol on the appliance means that the product is WEEE, i.e. "waste electrical and electronic equipment", according-

ly it must not be thrown out with unsorted waste (i.e. with "mixed household waste"), but it must be disposed of separately so that it can undergo

speciﬁc operations for its re-use, or a speciﬁc treatment, to remove and safely dispose of any substances that may be harmful to the environment

and remove the raw materials that can be recycled. Correct disposal of this product contributes to saving precious resources and avoiding potential

negative eﬀects on human health and the environment, which could be caused by inappropriate waste disposal. You are kindly asked to contact

your local authorities for further information regarding the designated waste collection points nearest to you. Penalties for improper disposal of such

waste can be applied in compliance with national regulations.

INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES

The EU WEEE Directive was implemented diﬀerently in each country, accordingly, if you wish to dispose of this appliance we suggest contacting

your local authorities or dealer to ﬁnd out what the correct method of disposal is.

INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUNTRIES

The crossed-out wheeled bin symbol is only valid in the European Union: if you wish to dispose of this appliance in other countries, we suggest

contacting your local authorities or dealer to ﬁnd out what the correct method of disposal is.

on page 20). Carry out operations in reverse order to insert them.

on page 20), then operate the handle