Select Cycle - Maytag W10254508A Guide D'utilisation Et D'entretien

8.

Select CYCLE

Turn cycle knob to select your wash cycle. See "Cycle Guide"
for details on cycle features. Not all options and settings are
available on all cycles.
9.
Adjust settings, if desired
The display will show the default settings for the selected
cycle. If desired, press the button beneath each setting to
adjust the Temp Level, Soil Level, and Spin Speed. Adjusting
settings will change the Estimated Time Remaining.
Overloading, unbalanced loads, or excessive suds may also
cause the washer to increase the cycle time.
You can also adjust the detergent concentration and water
hardness settings, if needed. Default settings are 2x detergent
concentration and normal water hardness. If the detergent
concentration is not listed on the package, see "About
Detergent Concentration" to calculate the concentration.
To Adjust Dispenser Settings:
1. Press DETERGENT CONC. until the desired concentration
appears on the time display.
2. Press WATER HARDNESS until the desired water hardness
appears on the time display.
NOTE: Not all settings are available on all cycles. See "Cycle
Guide" for available settings.
12
10.
Select any additional options
To add additional options to the cycle, such as Extra Rinse,
Fresh Hold , or Steam for Stains, press the button for the
®
desired options to add them to the selected cycle.
NOTE: Not all options are available with all cycles. See "Cycle
Guide" for available options.
11.
Setting a delayed start
+
-
If you do not want to begin a cycle immediately, you may
choose the DELAY START option. This will delay the start
of the wash cycle by up to 10 hours.
To set a delayed Start:
1. Press DELAY START + and – buttons to set the desired delay
time.
2. Press START/PAUSE to start the delay countdown.
The countdown stops blinking.
temp level soil level