Using The Dryer Controls; Select Cycle - Maytag Neptune Super Stack Guide D'utilisation Et D'entretien

D
U U
SING THE
Step 1
S C
ELECT YCLE
I I n n t t e e l l l l i i D D r r y y ® ® R R E E G G U U L L A A R R
IntelliDry REGULAR automatically senses the moisture in
®
the load and shuts off when the selected dryness level is
reached.This cycle is designed for loads such as towels,
underwear, t-shirts, jeans, etc. Set the control to the desired
dryness level (MORE DRY – LESS DRY).The triangle symbol
L between MORE DRY and LESS DRY is the initial preferred
setting for the majority of loads.
I I n n t t e e l l l l i i D D r r y y ® ® E E A A S S Y Y C C A A R R E E / / P P E E R R M M P P R R E E S S S S
IntelliDry EASY CARE/PERM PRESS automatically senses
®
the moisture in the load and shuts off when the selected
dryness level is reached.This cycle minimizes the wrinkling of
man-made fabrics (acrylic, nylon, polyester or blends) with an
extended cool-down; tumbling the load in unheated air at
the end of the cycle. Set the control to the desired dryness
level (MORE DRY – LESS DRY).The triangle symbol L
between MORE DRY and LESS DRY is the initial preferred
setting for the majority of loads.
T T I I M M E E D D R R Y Y / / A A I I R R F F L L U U F F F F
TIME DRY/AIR FLUFF may be selected for any load if the
IntelliDry sensor system is not used. Set the control to the
®
desired number of minutes.
D D A A M M P P D D R R Y Y
DAMP DRY is designed to "partially" dry items. It provides
approximately 20 minutes of heated tumbling and 5 minutes
of cool-down tumbling without heat.
W W R R I I N N K K L L E E R R E E L L E E A A S S E E
WRINKLE RELEASE will release wrinkles from items that are
clean and dry but slightly wrinkled, such as from a crowded
closet, suitcase or from sitting in the dryer too long after the
end of the cycle. It provides 10 minutes of heated tumbling
and 5 minutes of cool-down tumbling without heat.
C
RYER ONTROLS
NOTE: The dial can be turned in either direction to
select a cycle. Once started, the dial will not advance at a
specific rate during the IntelliDry
may not advance at all.Toward the end of the cycle,
(when the load begins to dry) the dial will advance at a
more regular rate and much more quickly.This is normal
operation.
12
cycles. At first, the dial
®