Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USA
14.2 Conditions that zero-set the wash
The cycle is cancelled, going to stop conditions, in the following cases:
•
in case of a fault
•
if the
Stop
button is pressed for more than 2sec
•
if the
Off
button is pressed.
14.3 Conditions preventing the start of washing
The cycle is inhibited in the following cases:
•
if the door is open; in this situation the message
•
if there is no water; in this situation the message
•
on alarm
•
during tank fi lling.
14.4 Conditions that block the wash cycle
The cycle times are blocked in the following cases:
•
if the door is opened
•
if there is no water (in version with
15. OPERATION
•
Insert the overfl ow pipe in the special seat inside the tank (standard version only). Make sure all the fi lters are properly
fi tted in their seats. The fi lters must be cleaned every 30-40 wash cycles and whenever necessary.
•
Do not operate the machine without fi lters and in particular the pump suction fi lters).
•
Close the door.
•
Open the water valve, turn the main wall switch on and start the machine pressing the key
LED lights up. After a few seconds the tank fi lling phase starts.
•
After fi lling, the machine automatically starts the heating phase.
•
The machine will be ready for washing only when the boiler and tank thermometers indicate that the required temperatures
have been reached, which are 180°F (82°C) for boiler and 160°F (71°C) for the tank.
•
Insert the special green rinse aid dispenser tube in the liquid rinse aid container (the transparent tube must only be
inserted in the detergent container) and check that the quantity is suffi cient for the daily requirement.
•
Insert the basket with dishes or various articles to be washed and close the door.
•
For cycle choice, select the wash cycle
and release when the LED of the required cycle lights up. The green LED of the selected cycle lights up
•
Start the cycle by pressing the key
of the selected cycle fl ashing. At the end of the cycle the indicator stops fl ashing and the message
display.
•
The machine is ready for a new wash.
It is advisable to change the tank water, by means of another fi lling, at least every 40-50
N.B.:
the machine does not accept other cycles until the door is opened or the key
The cycles
1, 2, 3, ∞
are factory-set with times of 120 - 180 - 240 - 300 seconds and can be changed with programming by
the installer.
Clean the machine at the end of the day (see chap.
Switch the machine off and close the water valve.
15.1 Dishes and cutlery loading
Before loading the dishes it is necessary to carry out a proper cleaning off of the food residuals.
It is not necessary to rinse the dishes with water before the loading.
WARNING: Do not wash items contaminated by petrol, paint, pieces of steel or iron, ash, sand, wax,
lubricating grease. These substances damage the machine. Do not wash fragile items or made of
material that do not stand the washing process.
page 42
USER SECTION
Door
is displayed for 4sec
H
O
will be displayed for 4sec (in version with
2
fl
owswitch).
1, 2, 3, ∞
with the key
A
for not more than 1sec (see pict. 10). Starting of the cycle is signalled by the indicator
16
Maintenance).
A
(see pict. 10) keeping it pressed for more than 5 seconds
A
is pressed twice (see pict. 10).
fl
owswitch)
B
(see pict. 10). The green
1, 2, 3,
END
appears on the
washes or twice a
day.
∞.
Publicité
Chapitres
Table des Matières
