Receiving The Machine; Storage; Prepare For Installation; Water Connection - Blakeslee UC-19 Notice D'installation, D'emploi Et D'entretien

USA

1.2 Receiving the machine

Pay special attention in choosing the lifting points and the machine barycentre during the loading and
unloading operations.
Before accepting the machine, verify that all the data on the data-plate corresponds to the required ones
(as shown on par. 1.1) and to the ones of the available electrical supply.
After unpacking, make sure the machine has not been damaged during transportation. If so, do notify the
seller immediately about the problem. If the damage might question the machine safety, do not install it.
Double check the fi rm tightness of all hose-clamps on piping, nuts, bolts and electrical connection
that might have come loose during transportation, to prevent water dripping leakages, or other damages, during
the machine operation.
See chap. 17 for disposing the packing material.
This machine has to be used in a place with room temperature between 41°F (5°C) and 95°F max (35°C). The room has
to be dry and ventilated.

1.3 Storage

Storage temperature: min. +40°F (+4°C) – max. +122°F (+50°C) - humidity <90%
The stored parts should be checked periodically to detect any sign of deterioration.
Do not store the machine exposing it to atmospheric agents (rain, sun, cold, etc.). Do not place material on the packed machine.

1.4 Prepare for installation

This is just a guide-line for the machine installation. The installation must be performed by a qualifi ed engineer.

1.5 Water connection

Water connections must be carried out in compliance with current local standards.
The water system must have characteristics between the parameters specifi ed in table 1.

Water supply characteristics

Static Pressure*
Dynamic Pressure
Cold water-supply temperature
Table 1
(machine with extra power)
Hot water-supply temperature
Capacity
*If higher than 60 PSI (400Kpa),
To improve the machine performance keep the temperature intervals indicated.
It has to be installed a water supply shut-off valve close to the machine in an accessible point.
Use only new fl exible pipes for the water connections.
1.6 Water supply characteristics
The machine water supply must be potable.
The inlet water must also meet the parameters given in the table 2.
Water parameters table
Chlorine
pH
Water hardness
Iron 3
Table 2
Manganese
Out of range values might lead to corrosion and jeopardize the life of the machine.
1
2 Should the water hardness is higher
3 Out of range values might lead scaling and sediments with a consequent lower performance, functionality, and expected
life of the machine.
Desired value: Out of range values might lead stainless steel blackening/tarnishing.
4
It is recommended a water test once a year.
page 32
INSTALLER SECTION
it is mandatory to install a pressure reducer.
1
4
it is compulsory
Min
30 PSI (~200Kpa) 60 PSI (~400Kpa)
30 PSI (~200Kpa) 50 PSI (~350Kpa)
110°F (~43°C)
140°F (~60°C)
2,6 gpm (~10 l/min)
to install a water softner and check periodically its operation.
Max
150°F (~65°C)
150°F (~65°C)
Min Max
2mg/l
6,5 8,5
1 3
8°f
2-3
0,2 mg/l
0,05 mg/l