Led Lighting; Notes; Calibration - Giropes Baxtran SS3 Mode D'emploi

User's Guide
3.9.6 bUZZEr (set buzze)
When menu displays bU22Er, press
confirm.
3.9.7 Change division value
When menu displays d, press
3.9.8 d-dP (Choose single or dual display)
When menu displays d-dP, press
is dual display. Press

3.10. LED LIGHTING

On powering on, long time press
LU-2, or LU-3. Press
4. NOTE
1. Not overloading. Not throw heavy things on the scale violently. The damage for overloading is not within the
range of guaranteed maintenance.
2. Don't use sharp thing to operation the keyboard. if the rubber is damaged it will influence the performance of
waterproof.
3. Keep the scale clean in order to weighing well.
4. There is a lead seal on the bottom of the scale. Users are not allowed to remove the seal. If the seal is da-
maged the scale is not guaranteed for maintenance.
5. a. You must charge the battery at least per 3 months when you don't use the scale for long time.
b. Please correctly connect line between adapter and battery, black to black, red to red.
c. If after charging the used time becomes short than often, please change a new battery.

5. CALIBRATION

This operation can only be done by competent authorized personnel according to the laws of each country.
1. With the scale turned off, unseal the seal of the division modification switch. This switch is located in the
inferior face of the scale.
2. To change the position of the switch of division modification.
3. Press the button ON/ 0 to turn on the scale.
T key until "CAL" appears in the screen, 0 will appear immediately, wait 5 seconds
4. Press the
5. Press the T key again, the maximum capacity of the scale will appear.
6. Locate on the scale the weight of its maximum capacity.
7. Wait 5 seconds.
8. Press the
and the scale automatically returns to the weighing mode.
9. Press the key OFF to turn off the scale.
10. Locate the switch of division modification to their original position.
11. Seal the modification switch again.
NOTES: during the calibration, if you want to quit, press ON/0.
14
T to enter, press SET/0~9 to choose division.
T to enter, press SET/0~9 to choose "n" or "y", "n" is single display, "y"
T to confirm.
0/ON, it shows LC-, press SET/0~9 to choose LU-0, LU-1,
T to confirm.
T key again, the message "CaEnd" will appear in the screen. The calibration has finished
Top Loading scale
T to enter, press SET/0~9 to choose "on" or "oFF", press
Model Super SS
T to