Publicité
Les langues disponibles
Les langues disponibles
Injector Elbow
Reinstall the main burner injector elbow—see figure
3. Ensure the proper injector for the desired fuel type.
Note the catalogue number from the Specifications
table on page 1 and the same number stamped on the
side of the injector elbow.
•
If converting to a LPG burner, DO NOT reinstall the
air shutter.
•
If converting to a NG burner, install the air shutter
supplied with this kit as shown in figure 3.
Pilot Injector
1.
Remove the pilot hood by pulling on it.
2.
Unscrew the pilot injector using an Allen key. Discard
the pilot injector.
3.
Replace with the appropriate pilot injector—see
Specifications table on page 1. Screw the new
injector.
4.
Refit the pilot hood by pushing down on it.
4
Install air shutter on
NG units only
Install air
shutter
slider (NG
Reconnect to pipe and
units only)
ensure it is gas-tight
Insert air
shutter
tab into
Tighten screw
top hole
with slider at
of slider
mid-point in
slot
Figure 3
Figure 4
Re-install
log retaining
bracket
Thread injector
elbow through
air shutter (if
used) into end
of burner
Suggested air shutter
setting (NG units only)
Suggested NG
air shutter setting
Publicité
