Publicité
Les langues disponibles
Les langues disponibles
Burner
Early models—Burner fixing nuts
accessible from underside of module
Early models: The burner fixing points are under the
burner module tray and the burner module assembly
must be removed. Proceed as follows:
1.
Remove the screw retaining burner module tray on
the right hand side as well as the 12 screws retaining
the module plate at the left side wall of the firebox—
see figure 1.
2.
Grab the burner module assembly, lift it slightly, twist
it upward and slide it towards the right and out to
allow the valve and receiver attached to the module
end plate through the left inner firebox wall as shown
below.
3.
Remove the front log retaining bracket from the
burner top at the right hand side and the injector
elbow with air shutter (NG) from the end of the
burner. Note that there is no air shutter on the LPG
burner. Unscrew the pipe nut while holding the
injector elbow with a wrench—see figure 2.
4.
Remove the main burner by removing the two nuts
from the underside of the burner tray.
5.
Replace the main burner by the appropriate fuel
burner fixing it back to the burner tray with the two
nuts.
Removing burner module from firebox
(firebox front transparent for clarity)
1
2
Later models—Burner fixing supports
accessible from the top of module
Later models: The burner is fixed to the burner tray
through two supports. The conversion can be done
without removing the burner module assembly from the
firebox.
1.
Remove the front log retaining bracket from the
burner top at the right hand side.
2.
Remove the injector elbow with air shutter (NG)
from the end of the burner. Note that there is no air
shutter on the LPG burner. Unscrew the pipe nut
while holding the injector elbow with a wrench—see
figure 2.
3.
Remove the main burner by removing the five
screws retaining the burner supports to the burner
tray.
4.
Detach the main burner from its supports and attach
the supports to the replacing burner.
5.
Refit the new main burner to its position by fixing the
burner supports back to the tray with the five screws
previsously removed.
Remove burner from
tray (5 screws)
Figure 2
Remove front log retaining
bracket (2 screws)
1
Remove front log
retaining bracket
3
Unscrew injector
elbow with air
shutter (NG) from
end of burner
2
Unscrew pipe
nut while holding
injector elbow
with wrench
3
Publicité
