Soundcore Life Note E Mode D'emploi page 5

Bluetooth Pairing
1 Tear off the insulation sticker on the earbuds before first use
2 Place the earbuds in the charging case and close it
3 Open the charging case no need to take out the earbuds , the earbuds will
automatically enter Bluetooth pairing mode
• The 3 LED indicators on the charging case will flash white in sequence
continuously
Select "Soundcore Life Note E" on your device's Bluetooth list to connect
4
• When successfully connected, the 3 LED indicators will turn white for 3 seconds
and then turn off
• Pairing with another device Place the earbuds in the charging case and
leave the case open To enter pairing mode, press and hold the button on the
charging case for 3 seconds until the 3 LED indicators flash white in sequence
continuously
• Each time you power on your Soundcore earbuds, they will automatically
connect to your last successfully connected device if available within the
Bluetooth range
• Mono mode When Bluetooth connected, you can use either one of the
earbuds only by placing the other one into the chaging case and closing it
3