Publicité
Les langues disponibles
Les langues disponibles
Install Ceiling Mounting Angles
Locate and mark the center of ceiling joist. Use a stud finder to locate the joists if ceiling is
3
finished with drywall.
Align center of keyhole slots on the ceiling
mounting angle with the centerline of the
4
ceiling joist and mark the holes on both
ends.
Install ceiling mounting angle into joist
6
using two 1/4" x 3" lag bolts, two 1/4"
washers and a 7/16" socket.
Pre drill 3" depth pilot holes fully into
3 inches of solid wood beam using a
5
3/16" drill bit. Note: Pilot hole must
bore into 3 inches of solid wood for lag
screw to be fully secured.
Note:
Make sure the lag bolts are tight against
the joist but DO NOT over-tighten the
lag bolts.
If lag bolts are over-tightened, the bolt
could snap or the hole may be stripped.
Warning:
VersaRac is designed for installation into wooden
ceiling joists only.
If the construction of your ceiling is using
engineered ceiling joists, please refer to "Fastening
to Engineered Joists" on page 14.
7
Publicité
