Baby Trend Go Gear Propel 35 Jogger Travel System Manuel D'instructions page 4

ASSEMBLY
IMPORTANT!
stroller, please follow these instructions carefully. Please
keep these instructions for future reference.
IMPORTANT!
inspect this product for damaged hardware, loose joints,
missing parts or sharp edges. NEVER use if any parts are
missing or broken.
IMPORTANT!
Remove stroller from box. The front wheel
and rear wheels MUST be installed prior
to use.
TO UNFOLD THE FRAME
To attach the front wheel, unfold stroller as
described in the section following:
1)
• Unlock the release lever (Fig. 1a).
adjust the handle, press the buttons on
both sides to move the handle up or
down to a comfortable position (Fig. 1b).
Release Button
Folded Stroller Position
5
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
To ensure safe operation of your
Before assembly and each use,
Adult assembly is required.
To
Fig. 1a
In Use Position 1 Control Position 2
Fig. 1b
• Rotate the release lever all the way up.
Put the handle in the control position as
shown in (Fig. 1c), and unfold stroller
frame by pulling upward on the stroller
handle until the frame locks (Fig. 1c).
FRONT WHEEL
2)
• Lean the stroller backwards so that the
front wheel posts are pointing upward.
Slide the front wheel onto the front fork
(Fig. 2). Skip to step (5) if this part has
already been assembled.
3)
• Slide the retainer plate onto the front
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
4)
• With the wheel in position, tighten the
axel nuts and tighten with standard
crescent, box, or open end wrench. You
should feel significant resistance and
the wheel should be held tightly in place
(Fig. 4).
Front Fork Front Fork
Slot Slot
Axel and Hub Axel and Hub
Axel Nut Axel Nut
Retainer Plate Retainer Plate
Fig. 3
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 1c
Fig. 2
Fig. 4
6