Beninca JACK24.50 Mode D'emploi page 18

Check the maximum height of the door is within the actuator field of use, to calculate compatibility between the height
of the door and number of max rotations of the gearmotor, refer to the following formula:
The radio receiver in this product is compatible only with ARC (Advanced Rolling Code) transmitters which, thanks to 28 bit coding, guarantee superior
anti-copying security.
1) DESCRIPTION AND INTENDED USE
Automation for balanced sectional doors available in two versions: JACK24.50 and JACK24.80.
Both models are equipped with an electronic limit switch (Absolute encoder), LED courtesy light and preparation for battery operation, using two 12V
batteries, art. JACK.24 CB
JACK available of an unlocking system for manual movement of the door in the event of a power cut.
Accessories are also available to install automation on the shafts with different dimensions to the standard 1" (25,4mm).
The product is equipped with an ESA SYSTEM to reduce consumption in StandBy, see ESA logic in paragraph 9.2.
Figure 2 lists the elements inside the packaging:
A
B
C
2) TECHNICAL DATA
Figure 1 indicates the valid dimensions for both models.
Mains power supply
Motor power supply
Control unit
Maximum power consumption
Maximum torque
Output speed
Shaft bore
Maximum door surface
Max. number output shaft rotations
Operating temperature
Operating cycle*
Number of transmitters saved
Protection degree
Lubrication
Weight
*Referred to sectional balanced door 6m x 3m
18
Maximum door height = 3.142 x d x 20
d = diameter of rope winding drum
ARC Transmitters
IMPORTANT, PLEASE READ CAREFULLY:
JACK 24.50
50 Nm
34 rpm
0.356 m/s with drum diameter 100
0.534 m/s with drum diameter 150
20 m 2
50 cycles/hour at 25°C
25 cycles/hour at 50°C
7,590 Kg
JACK Packaging
Fastening bracket
1 - Unlocking pendant
2 - Locking pendant
3 - Hex head screw M8
4 - Nut M8
5 - Washer
6 - Tabs
JACK gearmotor
230 Vac (50/60Hz) o 115Vac (50/60Hz)
24 Vdc
CP.JACK
3,3 A
0.230 m/s with drum diameter 100
0.345 m/s with drum diameter 150
1" (25,4mm)
20
-20°C /+50°C
512 ARC
IP40
Grease
JACK 24.80
80 Nm
22 rpm
35 m 2
30 cycles/hour at 25°C
15 cycles/hour at 50°C
7,690 Kg