S&P TD-350/100-125 SILENT Manuel D'instructions page 10

Instructions Manual
ENGLISH
Thank you for placing your confidence in
S&P by buying this product. It has been
manufactured following current technical
safety regulations and in compliance with EC
standard.
Please read this
carefully before installing or starting up the
product. It contains important information on
personal and user safety measures to be
followed while installing, using and carrying
out maintenance work on the equipment.
Once the product has been installed, please
hand in this booklet to the end user.
Check that the apparatus is in perfect
condition while unpacking. Any fault or
damage caused in origin is covered by the
S&P guarantee. Please make sure that the
apparatus coincides with the product you
have ordered and that the details on the
instructions plate fulfil your necessities.
Transport and manipulation.
- The packaging used for this apparatus has
been designed
transporting conditions. The apparatus
must always be transported in its original
packaging as not doing so could deform or
damage the product.
- The product should be stored in a dry
place in its original packaging, protected
from dust and dirt until it is installed in its
final location. Do not accept delivery if the
apparatus is not in its original packaging or
shows clear
manipulated in any way.
- Do not place heavy weights on the packed
product and avoid knocking or dropping it.
Important information for the safety of
installers and users.
- Installation must only be carried out by
qualified persons.
- Make sure that the installation complies
with each country's current mechanical and
electrical norms.
- Once ready to use, the apparatus must
fulfil the following standards:
- Standard for Low Pressure Instalments
2006/95/CE
instructions
to support
signs of having
- Standard
Compatibility 2004/108/CE.
- Ventilators, or apparatus that include them,
have been designed to move the air in the
area stipulated on their characteristics
plate.
- This apparatus must not be used in
explosive or corrosive atmospheres.
booklet
- If a ventilator is going to be installed to
extract air from premises where a boiler or
other combustion apparatus are installed,
make sure that the building has sufficient
air intakes to assure adequate combustion.
- The extractor outlet must not be connected
to a duct used to exhaust smoke or fumes
from any appliance that uses gas or any
other type of fuel.
- This appliance is not intended for use by
young children or infirm persons unless
they have been adequately supervised by
a responsible person to ensure that they
can use the appliance safely. Young
children should be supervised to ensure
that they do not play with the appliance
Safety during installation.
normal
- Make sure there are no loose elements
near the ventilator, as they could run the
risk of being sucked up by it. If it is going to
be installed in a duct, check that it is clean
of any element that could be sucked up by
the ventilator.
- When installing an apparatus, make sure
that all the fittings are in place and that the
structure which supports it is resistant
enough to bear its weight at full functioning
been
power.
- Before manipulating the apparatus, make
sure the mains supply is disconnected,
even if the machine is switched off.
- Check that the mains supply voltage and
frequency
stipulations on the characteristics plate.
- The electrical installation must include a
double
clearance of at least 3 mm, correctly sized
and in accordance with the electrical
standards of the country of installation
- Please follow the connections diagram for
the electrical connections.
- If an earth connection is necessary, check
that
for
values coincide
pole switch
it correctly connected
Electromagnetic
with the
with a contact
and that