Electrical Connection; Section 4. Operation; Submerging The Cleaner; Operating The Cleaner - Polaris 9100 SPORT Manuel Du Propriétaire

3.3 Electrical Connection

WARNiNg
Failure to comply with the following warnings
can result in permanent injury, electric shock or
drowning.
pREVENT ELECTRiCAL ShOCk
• Keep the control unit at least five (5) feet from the
edge of the pool (Canada 3m (10 ft.) per CEC
requirements). Never submerge the control unit.
• Only connect the control unit to a receptacle
protected by a GFCI. Contact a certified electrician
if you cannot verify that the receptacle is protected
by a GFCI.
• Do not use an extension cord to connect the
control unit.
• Do not allow anyone to swim while the Polaris
9100 Sport robotic cleaner is in the pool.
For your safety and to obtain the best possible
performance from your Polaris 9100 Sport, connect the
cleaner's floating cable to the cleaner's control unit by
twisting the threaded connector until it is snug. Do not
overtighten. Refer to Figure 3.
Control Unit
Figure 3. Electrical Connection
The green indicator light on the control unit will
illuminate for a short period to indicate that the cycle
is ready to start. Do not try to start a cycle until the
indicator is illuminated.
iMpORTANT
The Polaris 9100 Sport control unit is equipped with
an automatic shut off feature to prevent overheating
if operated in direct sunlight for an extended period of
time.
®
Floating Cable
Threaded Connector
WARNiNg
The Polaris 9100 Sport control unit is water-
resistant, not waterproof. In order to prevent the
risk of electric shock which could result in serious
injury or death, never submerge the control unit.

Section 4. Operation

4.1 Submerging the Cleaner

1. While holding the cleaner by the handle,
submerge the cleaner in the pool and remove
any air trapped inside by keeping the unit
vertical. Make sure that the cleaner sinks to
the bottom of the pool. Refer to Figure 4.
Figure 4. Submerge the Cleaner Vertically
2. Spread the floating cable out over the pool,
ensuring there are no kinks or bends in the
cable. Refer to Figure 5.
Figure 5. Spread Floating Cable Over the pool

4.2 Operating the Cleaner

1. To start your Polaris 9100 Sport robotic
cleaner, press the ON/OFF button. Refer to
Figure 6. The green indicator light illuminates
and the cleaner will start up after just a few
seconds.
Page 7