Maintenance - Baby Trend Falcon Jogger Manuel D'instructions

MAINTENANCE

FENDER
If adjustment or replacement is necessary:
• To remove the front fender: follow
20)
(Fig. 20a). Use a phillips screwdriver to
remove the 2 screws under the frame.
(Fig. 20b).
• Remove footrest to access nut. You
21)
can use a standard crescent wrench to
tighten the nut (Fig. 21).
DO NOT OVER TIGHTEN this can
cause damage to the wheel housing.
• To reinstall fender: Insert the 2 screws
22)
through the front frame assembly into the
front fender's plastic tubes. Tighten the
screws only until snug (Fig. 20b).
DO NOT OVER TIGHTEN.
17
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 20a
Screws
Fig. 20b
Fig. 21
REATTATCHING
FRONT WHEEL
• Slide the front wheel onto the front fork
23)
(Fig. 23).
• Slide the retainer plate onto the front
24)
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel
(Fig. 24).
• With the wheel in position, tighten the
25)
axel nuts and tighten with standard
crescent, box, or open end wrench. You
should feel significant resistance and
the wheel should be held tightly in place
(Fig. 25).
SEAT PAD
• To clean the seat pad, use only mild
household soap or detergent and warm
water on a sponge or clean cloth.
OTHER
• Check your stroller for loose screws,
worn parts, torn material or stitching on
a regular basis. Replace or repair parts
as needed.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits
MAINTENANCE
Fig. 23
Front Fork
Slot
Axel and Hub
Axel Nut
Retainer Plate
Fig. 24
Fig. 25
réservés.
18