Setting Up Your C1500Ss Display; System Requirements; Unpacking Your Touch Display; Mounting The C1500Ss Display - 3M MicroTouch C1500SS Guide D'installation

5
CHAPTER 2

Setting Up Your C1500SS Display

Setting up your display:

Unpack the components

Connect the video, touch sensor, and power cables

Power on the display and test your setup

Install the touch software

Calibrate the touch sensor

System Requirements

The requirements for your PC are as follows:
 Available RS-232 serial communication (COM) or USB port.
 Unique interrupt request (IRQ) available to the COM port that the touch sensor will
use. The touch sensor cannot share an IRQ with another device.

Video card and video driver already installed for the display
Workspace should be a sturdy, level surface.

Unpacking Your Touch Display

Carefully unpack the carton and inspect the contents:
 SVGA video cable
 RS-232 serial communication cable (or USB cable if applicable)
 Optional AC/DC power supply (12V DC output)
 AC power cable
 CD with touch software, documentation, and utilities
 Hardware kit (includes mounting brackets, screws, washers)

Mounting the C1500SS Display

The display has a bezel already mounted to act as an interface with a front mounting
surface.
TSD-30219
3M™ MicroTouch™ Display C1500SS Installation Guide
Rev F