Regulatory Agency Approvals - 3M MicroTouch C1500SS Guide D'installation

Masquer les pouces Voir aussi pour MicroTouch C1500SS:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 139
16

Regulatory Agency Approvals

The C1500SS Display complies with the following regulatory standards:
 FCC-B
 CE
 UL/cUL
 C-Tick
This equipment has been tested and found to comply within limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection, against harmful interference in residential installations. This
equipment generates, uses and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may case harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio or television
equipment reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
 Reorient or relocate the receiving antenna.
 Move the equipment away from the receiver.
 Consult the dealer or an experienced radio/television technician for additional
suggestions.
 You are cautioned that any change or modification to the equipment not expressly
approved by the party responsible for compliance could void your authority to operate
such equipment.
 This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
 Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur
le matériel brouilleur du Canada.
 This device complies with Part 15 of the FCC rules: Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
 Properly shielded and grounded cables and connectors must be used in order to meet
FCC emission limits. 3M Touch Systems is not responsible for any radio or television
interference caused by using other than recommended cables and connectors or by
unauthorized changes or modifications to this equipment. Unauthorized changes or
modifications could void the user's authority to operate the equipment.
TSD-30219
3M™ MicroTouch™ Display C1500SS Installation Guide
Rev F

Publicité

Table des Matières
loading

Table des Matières