MBM PLG74TG Manuel D'installation Et D'utilisation page 41

When cooking is over, remove the
item from the appliance using the spe-
cific cookware and put it in a place
prepared beforehand.
During cooking, check the level of
liquid inside the container fre-
quently. (see chap. 5 / Deactivation)
Do not empty the cooking fat con-
tainer into the ash container (900
Model). Follow the disposal proce-
dures in force in the country of use / see
ILL sect. - REF q) Fig. 4/C and Fig. 5.
DEACTIVATION / SEE CHAPTER 5
BURNT OIL DRAIN/ASH / SEE
SECT. IMAGES - REF. Q)
Before operating, wait for the
burnt oil to cool off.
The burnt oil collection container
has a limited capacity. Keep an
eye on the container as it fills
while oil is emptied from the cooking
compartment.
Do not fill the oil collection con-
tainer beyond 3/4 its capacity to
handle it safely.
Remove the containers from their
•
seats and empty them following the
disposal procedures in force in the
country of use (700 Model Fig. 4/B
and Fig. 5 / 900 Model Fig. 4/B + Fig.
4/C and Fig. 5)
When finished, put the emptied con-
•
tainers back in place.
Close the network locks upstream
•
the appliance (Gas - Water - Electric).
Check the cleanliness and hygiene
•
of the appliance and of the cooking
containers. See "Maintenance".
REPLACING LAVA STONE / see
SECT. IMAGES - REF. o)
•
Wait for the temperature of the
hotplate to cool off so that the opera-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
INSTRUCTIONS FOR USE
tor is not burnt.
•
Lift the cooking plates and remove
them (Detail A).
•
Removed the worn stones (Detail B).
•
Clean the housing of the stones (De-
tail C) and the ash containers, pul-
ling them from their seat inside the
appliance (Detail G).
•
Reposition the collection containers
in their housing.
•
Distribute uniformly in the proper lo-
dging the new lava stone contained
in the sack supplied (about 6 kg me-
dium size) to grant the stability of the
grills on the splashguard (Detail B).
•
Place again the cooking grills pre-
viously removed (Detail A).
NEW! "BRIQUETTE" LAVA STO-
NE LOAD (OPTIONAL) / VD. SECT.
ILL - REF n)
In the models provided, lift and remove
the cooking grids (Part A).
Place the lava stone called "bri-
quette" in the special housing. Mo-
del 700: No. 50 pieces / grid, about
5 kg ; Model 900: n. 65 pieces / grid,
about 6.5 kg.
Place the lava stone correctly
as shown (Part G).
Replace the cooking grills previously
removed.
"BRIQUETTE" LAVA STONE
REPLACEMENT /
In the models provided, see par. "Lava
stone replacement" up to point 5 and
then proceed with:
6. Correctly place the new lava stone
known as a "briquette", approx. 5 kg /
700 mod - 6.5 kg / 900 mod, into the
designated housing (Det. C)
7. Put the previously removed cooking
grill back in place (Det. A).
Proceed with the other opera-
tions (eg Ignition etc.)
- 17 -
8.
EN