Videotec NXMH2 Manuel D'instructions page 5

Position the resistance cables under
the inner slide of the housing.
Fig. 03
Assemble the support circuit (01) on the inner slide
of the housing using the related spacers (02) and
the fastening screws (03). Assemble the rubber
wire guide (04) on the hole of the inner slide.
Fig. 04
Pass the resistance cables through the
hole surrounded with the rubber.
Fig. 05
Make the electrical connections of the resistance
to the HEATER terminal on the support circuit.
Fig. 06
03
01
02
Fig. 07
h For the 115/230Vac heater is necessary
04
to connect the ground cable from the
electronic card to the connection arranged
on the rear cover plate of the housing.
Fig. 08
Close the housing, proceeding in the
reverse order to that described above.
IN 230Vac
OUT Heater OUT
230Vac 230Vac
IN 12Vdc/24Vac
OUT Heater OUT
12Vdc/24Vac 12Vdc/24Vac
3