MBM PEE7750I Manuel D'installation Et D'utilisation page 27

ADDRESSEES / This document is
drawn up as follows:
- Homogeneous operator / Expert
operator authorised for handling, tran-
sporting, installing, servicing, repairing
and scrapping the equipment.
- Generic operator / Person authori-
sed and employed to operate the ap-
pliance with guards active, capable of
performing routine tasks.
OPERATOR TRAINING
PROGRAM / By specific request, it is
possible to carry out a training course
for users, installers and technicians,
following the procedures indicated in
the order confirmation.
PRE-ARRANGEMENTS
DEPENDING ON CUSTOMER /
Unless different contractual agreemen-
ts were made, the following normally
depend on the customer:
• setting up the rooms (including ma-
sonry work, foundations or channelling
that could be requested);
• smooth, slip-proof floor;
• pre-arrangement of installation place
and installation of equipment respecting
the dimensions indicated in the layout
(foundation plan);
• pre-arrangement of auxiliary services
adequate for requirements of the sy-
stem (electrical mains, waterworks, gas
network, drainage system);
• pre-arrangement of electrical system
in compliance with regulatory provi-
sions in force in the place of installation;
• sufficient lighting, in compliance with
standards in force in the place of instal-
lation;
• safety devices upstream and down-
stream the energy supply line (residual
current devices, equipotential earthing
systems, safety valves, etc.) foreseen
by legislation in force in the country of
installation;
• earthing system in compliance with
standards in force;
• pre-arrangement of a water softening
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
- 3 -
system, if needed (see technical de-
tails).
CONTENTS OF THE SUPPLY /
The supply vary depending on the
order.
• Appliance
• Lid/s
• Metallic rack/s
• Rack support grid
• Pipes and/or wires for connections to
energy sources (only when indicated in
work order).
INTENDED USE / This device is in-
tended for professional use. The use
of the appliance treated in this docu-
ment must be considered "Proper Use"
if used for cooking or regeneration of
goods intended for alimentary use; any
other use is to be considered "Improper
use" and therefore dangerous.
These appliances are intended for
commercial activities (e.g. restaurant
kitchens, canteens etc) and in commer-
cial companies (e.g. bakeries etc.) but
not for the continuous food production.
The appliance must be used accor-
ding to the foreseen conditions stated
in the contract within the prescribed
capacity limits carried in the respecti-
ve paragraphs.
Only use original accessories and
spare parts supplied by the manu-
facturer to maintain regulatory com-
pliance.
ALLOWED OPERATING
CONDITIONS / The appliance has
been designed to operate only inside
of rooms within the prescribed techni-
cal and capacity limits. The following
indications must be observed in order
to attain ideal operation and safe work
conditions.
The appliance must be installed in a su-
itable place, namely, one which allows
normal running, routine and extraordi-
nary maintenance operations. The ope-
rating area for maintenance must be set
1.
EN