Carrycot Set Up - Ickle Bubba Stomp Mode D'emploi

Step 1: Preparing the Carrycot
Recline Lever
Recline Buttons
a. The carrycot fabric should already be attached to the carrycot/seat unit frame.
PLEASE NOTE: The position of the carrycot may need to be adjusted to make
it level. This can be done by firmly pressing on the recline buttons located either
side of the carrycot frame, as shown above.
Step 2: Bumper Bar Installation
a. Line up the holes on each side
before pushing firmly into place.

Carrycot Set Up

b. To remove, press the centre button
(A) inwards whilst pulling the bumper
bar upwards.
v.07.20
8
A