Ickle Bubba Stomp Mode D'emploi page 7

Step 2: Brake Bar Installation
a. Please ensure the chassis is
unfolded before installing the brake bar
and wheels.
Attach the brake bar to the rear of the
chassis as shown above.
Step 3: Rear Wheel Installation
a. To attach the rear wheels simply press the centre button whilst pushing on to
each side of the axle. Test this by trying to remove the wheels without pressing the
centre button.
To disassemble the wheels push the centre button and pull.
Set Up & Assembly
v.07.20
6
b. Ensure the silver locking clips are
visible on each side and test this by
pulling the brake bar downwards once
it has been installed.