Fein ASCM14 Mode D'emploi page 19

OBJ_BUCH-0000000126-002.book Page 19 Tuesday, March 11, 2014 11:29 AM
Switching on and off (figure 13).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
In case of overload, the machine switches off.
Thermal overload of the power tool is indi-
cated through flashing of the LED in the han-
dle.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Illumination (figure 14).
Never look or stare into the
WARNING
light of the power tool's lamp
from a short distance. Never point the light of
the lamp into the eyes of other persons in
close vicinity. The radiation produced by the
lamp can be harmful for the eye.
When pressing the On/Off switch, the light is
switched on.
After releasing the On/Off switch, the light
briefly stays on and then switches off auto-
matically.
Fig. 13
1. 2.
Fig. 14
Light
en
19
On/Off switch