Knick Protos 3400 Mode D'emploi page 25
Module régulateur pid d'utilisation générale
Masquer les pouces
Voir aussi pour Protos 3400:
- Manuel utilisateur (308 pages) ,
- Mode d'emploi (69 pages) ,
- Instructions d'installation (2 pages)
Publicité
Les langues disponibles
Les langues disponibles
Inserting the Module
Thanks to the staggered arrangement
of connectors and fastening screws the
terminal strips of all modules are easy to
access.
1.
Switch off power supply
2.
Open the device (loosen the 4 screws at the front)
3.
Place module in slot (D-SUB connector)
4.
Tighten fastening screws of the module
5.
Connect signal lines.
6.
Close device, tighten screws at the front
7.
Switch on power supply
8.
Set parameters
PID 3400(X)-121
Make sure that the cable
glands are tightly closed to
protect against humidity.
25
Publicité
