Pur Line COOLY 9000 A Mode D'emploi page 36

CLEANING UP OF REFRIGERANT
1. Gas/vapor heavier than air. May accumulate in confined spaces, particularly at or below
ground level.
2. Eliminate every possible source of ignition.
3. Use appropriate personal protection equipment (PPE).
4. Evacuate unnecessary personnel, isolate, and ventilate area.
5. Do not get in eyes, on skin, or on clothing. Do not breathe vapors or gas.
6. Prevent entry to sewers and public waters.
7. Stop the source of the release, if safe to do so. Consider the use of water spray to disperse
vapors.
8. Isolate the area until gas has dispersed. Ventilate and gas test area before entering. Contact
competent authorities after a spill.
TROUBLESHOOTING
Troubles
UNIT DOES NOT
START WHEN
PRESSING POWER
BUTTON
Not cool enough
Noisy
E2 Code
E3 Code
E4 Code
Possible Causes
Water full indicator lamp blinks, and
water tank is full.
Room temperature is lower than the
setting temperature. (Cooling mode)
The doors or windows are not closed.
There are heat sources inside the
room.
Exhaust air hose is not connected or
blocked.
Temperature setting is too high.
Air inlet is blocked.
The ground is not level or not flat
enough
The sound comes from the flowing
of the refrigerant inside the air
conditioner
Ambient temperature sensor failure.
Coil temperature sensor failures.
Full water warning.
EN
Suggested Remedies
Dump the water out of the water tank.
Reset the temperature
Make sure all the windows and doors
are closed.
Remove the heat sources if possible
Connect or clean the exhaust air hose.
Reset the temperature
Clean the air inlet.
Place the unit on a flat, level ground
if possible
It is normal.
Check connection or replace it. To
clean or replace the temperature
sensor.
Check connection or replace it. To
clean or replace the sensor.
Drain the water.
34