Publicité
Les langues disponibles
Les langues disponibles
SLEEP
This mode can be selected when the unit is under Cool mode.
Press the Sleep button
to low speed automatically. The set temperature will increase 1ºC after 1 hour, and increase 2°C
after 2 hours. After 6 hours, the unit will stop running.
OSCILLATION
Press the button
, to activate the automatic oscillation of the slats for better air distribution.
Press again to stop this function.
Notice:
The main control board has memory function, when the unit is ready to run but in stop status, the
main control board can memorize the initialization of working mode (Not available under AUTO
mode).
REMOTE CONTROL
1
2
3
4
To operate the air conditioner, aim the remote control at the signal receptor. The remote controller
will operate the air conditioner at distance of up to 5m (16.4 feet) when pointing at singal receptor
of the air conditioner.
Notes
- Do not mix old and new batteries at the same time in remote controller.
- Take out the batteries when the remote is not in use for a long time.
- If the remote control does not work in a short distance from the unit, please change the batteries.
- Do not allow the children to play with the remote control.
- Batteries must be disposed of in special authorized containers. They should never be thrown into
the fire.
EN
in Cool mode, the unit will work under sleep mode and the fan will turn
1. Power button: Press to turn on/off the device
2/3. Increase/Decrease buttons: Press to adjust room
8
temperature and the timer
4. Timer button: Press to set automatic on or off
5. Sleep button: Press to set or cancel sleep mode
7
6. Speed button: Press to select fan speed
7. Mode button: Press to select the operation mode
8. Oscillation: start/stop the movement of the louvers.
6
Insert batteries
Slide the cover to open
5
1. Open the back cover, take off the isolating film on the batteries.
2. Put the batteries inside the slot, with anode and cathode in
right directions.
3. Put on the back cover.
32
Publicité
