KRATOS SAFETY FA 70 002 00 Mode D'emploi page 7

of the annual inspections.
The more you take care of your equipment, the longer it will last. However, we recommend replacing your equipment at least every 10 years.
The equipment should be inspected if there is any doubt, or following a fall, and at least annually, by the manufacturer or a competent person* and in
strict compliance with the manufacturer's periodic inspection procedures (and in particular the inspection guides ref. GI XX-XXXXXX-XX) to check
its strength and therefore the user's safety. The product data sheet should be completed (by writing) after each verification; date of inspection and date of
next inspection must be indicated on the data sheet, it is also recommended to put date of next inspection on the product.
*: refer to the definition of a competent person on our website under: Info/Technical Advice
MAINTENANCE AND STORAGE: (Instructions to be strictly respected)
During transport, keep the equipment away from any sharp part and protected in its packaging. Clean with soapy water, dry with a dry cloth and hang
it in a naturally ventilated area away from any direct fire or heat source, as well as any elements which became wet during their usage. Bleaches and
detergents are strictly prohibited. The equipment must be stored in a temperate, dry and ventilated area in its packaging protected from sunlight, heat
and chemical products.
7