Fein ASCD12-100W4 Mode D'emploi page 19

OBJ_BUCH-0000000230-002.book Page 19 Tuesday, March 21, 2017 9:05 AM
Selecting the rotation direction
(figure 9).
To avoid accidental starting, e. g., during
transport, set the rotation selector switch to
the centre position.
Set the rotation selector switch to right or left
rotation as required.
Adjust the rotation selector switch only
when the machine is at a complete stop.
Switching on and off (figure 10).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
In case of overload, the machine switches off.
Thermal overload of the power tool is indi-
cated through flashing of the LED in the han-
dle.
Apply the power tool to the nut or screw
only when switched off, as a rotating applica-
tion tool could slip off.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Fig. 9
Rotational direction switch
Fig. 10
1.
2.
en
19
On/Off switch