DeFelsko PosiTector UTG Notice D'instruction page 3

Introduction
The PosiTector UTG is a hand-held Ultrasonic Thickness Gage that
uses the non-destructive ultrasonic pulse-echo principle to measure
the wall thickness of a wide variety of materials. It consists of a body
(Standard or Advanced) and probe.
Quick Start
Press the button to power up the Gage. To conserve battery
life, the gage will automatically go to sleep after 5 minutes of
inactivity. While in Sleep Mode, the gage powers up significantly
faster— convenient when moving between parts or locations. The
gage will completely power off after 4 hours of inactivity.
Alternatively, select Power Off from the main menu. All settings
are retained.
1. Remove the protective rubber cap from the probe.
2. Power-up Gage by pressing the center navigation
button.
3. Zero the probe (pg. 8).
4. Verify accuracy and adjust if necessary (pg. 7).
5. Measure the part (pg. 5).
Menu Operation
To access the Menu, power-up the gage, then press the center
navigation button . Either the keypad or touch screen can be
used to navigate the menu. If desired, touch screen functionality
can be disabled within the Setup menu (See Touch, pg. 12).
Select a menu option by touching it, or use the and but-
tons to highlight the desired option and press to select it.
On menus longer than one page, the current page number is dis-
played below the menu name. Navigate between pages using
when the first menu item is selected, or when the last
menu item is selected. If using touch, navigate between pages
by touching or , or by swiping up or down.
Press the button or swipe right to return to a previous screen.
Select Exit to close the Menu.
1