Publicité
Les langues disponibles
Les langues disponibles
Use of remote control
Fan On/off
Fan Speed Level 2
Fan Speed Level 1
Fan Speed Level 6
Auto off after 1hr
Auto off after 4hrs
Light ON
Care and Cleaning
WARNING: Make sure the power is off before cleaning your fan.
Because of the fan's natural movement,some connections may
become loose.Check the support connections,brackets,and blade
attachments twice a year. Make sure they are secure. lt is not
necessary to remove the fan from the ceiling.
Clean your fan periodically to help maintain its new appearance over
the years. Do not use water when cleaning, as this could damage the
motor or the wood, or possibly cause an electric shock. Use only a
soft brush or lint-free cloth to avoid scratching the finish.The plating
is sealed with a lacquer to minimize discoloration or tarnishing.
You can apply a light coat of furniture polish to the wood for
additional protection and enhanced beauty.Cover small scratches
with light application of shoe polish.
You do not need to oil your fan.The motor has
permanently-lubricated sealed ball bearings.
Natural Wind
Fan Speed Level 3
Fan Speed Level 4
Fan Speed Level 5
Turn forward/reverse
Auto off after 2hrs
Auto off after 8 hrs
Light OFF
16
Troubleshooting
Problem
Check the main and branch circuit fuses or breakers.
Check the line wire connections to the fan and switch
wire connections in the switch housing.
Ensure all motor housing screws are snug.
Ensure the screws that attach the fan blade bracket to
the motor hub are tight.
The fan
Ensure the wire nut connections are not ratting against
will not
each other or the interior wall of the switch housing.Allow
start
a24-hour ""breaking in" period.Most noises associated
with a new fan disappear during this time.
If you are using the Ceiling Fan light kit,ensure the
screws securing the glassware are tight.Check that the
light bulbs are also secure.
Ensure the canopy is a short distance from the ceiling.It
should not touch the ceiling.
Ensure your outlet box is secure and rubber isolation
pads were used between the mounting plate and outlet
box.
Check that all blades and blade arm screws are secure.
Most fan wobble problems are caused when blade levels
are unequal.
Check this level by selecting a point on the ceiling
above the tip of the blades.
The fan
Measure from a point on the center of each blade to the
wobbles.
point on the ceiling.Measure this distance.Rotate the
fan until the next blade is positioned for measurement.
Repeat for each blade.Any measurement deviation
should be within 1/8 in.
Run the fan for ten minutes.if the fan continues to
wobble please contact Customer Service.
Solution
17
EN
Publicité
