Publicité
Les langues disponibles
Les langues disponibles
Assembly - Hanging the Fan(continued)
Preparing for mounting
Install remote control
Preparing for mounting
1.Carefully push the
canopy to the bottom of
the mounting bracket,
make two sliding holes
aligned to the two
prominent screws on the
mounting bracket, and
then turn clockwise until
tight.
2.Push the canopy ring to
the bottom of the
canopy,slide the inner
holes aligned to the two
prominent screws on the
mounting bracket again,
and turn the canopy ring
clockwise until tight.
1:Remove the mounting
bracket from the canopy
by loosening the two
canopy screws located in
the L shaped slots.
2:Remove and save the
two canopy screws in the
round holes.
This will enable you to
remove the mounting
bracket.
12
Assembly - Attaching the Lights
1.Connecting lamp wire
CAUTION:To reduce the risk of electric shock,disconnect the
electrical circuit to the fan before installing the light fixture.
Phillips
screwdriver
Phillips
screwdriver
The female terminal
The male terminal
1.Remove the pre installed
screws and install the lamp
at the specified position
1: Put the LED light source
into the disc(the LED light
source has a magnet,which
can be directly magnetized
on the disc)
2: Pass the LED lead of the
motor through the hole in
the middle of the LED light
source.
3: Then plug the male
terminal of LED lead into
the female terminal of LED
light source.(as shown in
figure)
13
EN
Publicité
