Publicité
Les langues disponibles
Les langues disponibles
Installation of the hanging bracket (suspension part)
WOODEN CEILING
Mounting Bracket<A>
Self-tapping screw<B>
For wooden ceiling, use wood screw to drill on the wooden beam or the
"junction box"to fix the hanging bracket (selection is made according to actual
requirements of the customers).
STEP 1 A-WOODEN CEILING
SWITCH OFF THE ELECTRICAL MAINS AT THE CIRCUIT BREAKER FUSE BOX
1)Use the Mounting Bracket(A) as a guide, mark the spots where the 4
Self-tapping Screws (B) will be drilled.
2)Remove the Mounting Bracket(A), drill 4 holes for 3MM diameter, install the
mounting bracket onto wooden ceiling with the 4 Self-tapping Screws(B).
IMPORTANT : SCREWS MUST BE TIGHTENED TILL SNUG
08
Installation of the hanging bracket (suspension part)
CONCRETE CEILING
Mounting Bracket<A>
Expension Bolts<B>
Flat Washers <C>
Spring Washers<D>
Note: According to the ceiling of different materials, use different screws
to fix the hanging bracket.Don't fix the hanging bracket on the wood
ceiling less than 12MM to prevent danger caused by loosening of screws.
After the hanging bracket is completed, ensure that it can withstand the
tension test of more than 150LBS for safety.
For concrete ceiling, use the percussion bit with diameter 8mm to drill holes
according to the length of expansion screws.Then use the attached
expansion screws to fix the hanging bracket onto the ceiling (selection is made
according to actual requirements of the customers).
STEP 2 A-CONCRETE CEILING
SWITCH OFF THE ELECTRICAL MAINS AT THE CIRCUIT BREAKER FUSE BOX
1)Use the Mounting Bracket(A) as a guide, mark the spots where the 4
Expansion Bolts (B) will be drilled.
2)Remove the Mounting Bracket(A), drill 4 holes and insert 4 Expansion Bolts
(B)into the concrete ceiling, install the mounting bracket and secure with Flat
Washers (C), Spring Washers (D) and Nuts (E).
IMPORTANT : SCREWS & NUTS MUST BE TIGHTENED TILL SNUG
Nuts<E>
09
EN
Publicité
