Mounting Or Removing Of The Footrests; Suspension - Vermeiren Forest Mode D'emploi

The armrests are adjustable in different heights over a range of 100 mm (stepless).
1. Loosen the lever
2. Move the square tubes
3. Retighten the lever
4. Check that the lever
5. Adjust the other armrest with the same instructions.
2.5

Mounting or removing of the footrests

L L L L
CAUTION:
Risk of injury – Make sure that you hold on the upper curve to prevent
your fingers from getting caught and hurt.
L L L L
CAUTION:
Risk of injury – Make sure that the footrests are firmly fixated.
To take off the footrests:
1. Fold the foot plates upwards.
2. Pull or push on lever
3. Turn the footrest to the outside of the wheelchair until the hole comes loose of the pin
from attachment point
4. Pull the footrest upwards until the pins
2.6

Suspension

L L L L
CAUTION:
Risk of injury – Set the range of both springs identically.
The strength of the springs above the drive motors can be adjusted to enhance your comfort.
These springs are located on the back of the electrical wheelchair, next to the battery cover.
a little.
and over each other until the desired armrest height.
hand-tightened.
is securely fixed.
.
.
come out of the holes
If you turn the adjuster
spring lengthens and the suspension becomes softer.
If you turn the adjuster
spring shortens and the suspension becomes firmer.
Page 13
Forest, Forest Narrow
The mounting of the footrests is
done as follows:
1. Hold the footrest sideways at the
outside of the wheelchairs frame
and mount the pins
holes .
2. Turn the footrest inwards till the
pin click in the hole of the
attachment point . The lever
must point backwards. If the
footrest does not engage
immediately, push them lightly
inwards.
3. Turn the foot plates downwards.
.
to the left, the range of the
to the right, the range of the
2012-12
into the