Model Description; Model Designation; Specifications; Plug Configurations - Hatco HDWTC-2 Manuel D'installation Et D'utilisation

MODEL DESCRIPTION

All Models
All Hatco Drawer Warmers are built of rugged aluminized and
stainless steel with durable nylon rollers, 12 gauge stainless
steel slides, and heavy-duty hardware. Each unit features
adjustable drawer vents for humidity control, a touchscreen
controller, a Power I/O (on/off) switch. Standard size pans 6"
(152 mm) deep are supplied with each drawer. Each drawer
can be adjusted to different depths to fit different size pans. The
insulated top and sides provide maximum energy efficiency
and the heating elements are warranted for two years.
HDWTC models are available in one, two, and three-drawer
versions and include a 6' (1829 mm) power cord with plug.
They are equipped with 4" (102 mm) adjustable legs.
NOTE: Refer to the OPTIONS AND ACCESSORIES section of
this manual for all of the available options and accessories.

MODEL DESIGNATION

SPECIFICATIONS

Plug Configurations

Units are supplied from the factory with an electrical cord and
plug installed. Plugs are supplied according to the application.
WARNING
ELECTRIC SHOCK HAZARD: Plug unit into a properly
grounded electrical receptacle of the correct voltage,
size, and plug configuration. If plug and receptacle do not
match, contact a qualified electrician to determine and
install proper voltage and size electrical receptacle.
NOTE: The specification label is located on the back of the
units. See label for serial number and verification of
unit electrical information.
H D W T C - x
Heated
Drawer Warmer
Touchscreen Control
Touchscreen
Controller
USB Slot
Drawer
Vents
4" (102 mm)
Adjustable Legs
Model HDWTC-2
Quantity of Drawers
CEE 7/7 Schuko
Plug Configurations
NOTE: Receptacle not supplied by Hatco.
4
English
Power I/O
(on/off) Switch
NEMA 5-15P
BS-1363
Form No. HDWTCM-0121