Using Timers; Changing The Timer Settings; Updating The Firmware - Hatco HDWTC-2 Manuel D'installation Et D'utilisation

OPERATION
Using the Timers
Use the following procedure to use timers for the product in the
drawer warmer.
1. Touch the key to display the Timers Screen.
NOTE: The position of the timers on the screen corresponds
with the position of the drawer in the drawer warmer,
when viewing from the operator side.
2. Start the desired timer(s).
• Touch a timer to start a
countdown from the pre-set
time setting.
• Touch and hold a timer for
three seconds to turn off
and reset the timer.
• When a timer has one
minute remaining, it will be
highlighted in flashing red. When a timer reaches zero,
the unit will beep three times and the red highlight on
the timer will remain solid until it is reset by the operator.
3. Press and hold the red highlighted timer for three seconds
to reset the time.

Changing the Timer Settings

Use the following procedure to change the time setting on each
of the product timers.
1. Move the Power I/O (on/off) switch to the I (on) position.
• The unit will turn on and the touchscreen controller will
energize and show the Home Screen.
2. Touch the key.
• Enter the password [2 4 8]
using the number keys that
appear.
• The Service screen will
appear on the display.
3. Touch the TIMERS key on the
Service screen to access the
Timers Screen.
4. Touch the SET key to highlight
the first timer setting.
5. Touch the red or
on the display to change the
timer setting.
6. Touch the next desired timer
setting to make it active
for change, and repeat the
previous step to change the setting.
7. Touch the DONE key when timer setting changes are
complete.
8. Touch the key to save the settings and return to the
Home Screen.
0:40:00
0:40:00
0:40:00
Service
Firmware Usage
Control Timers
Testmode
0:45
0:45
key
0:45
Set

Updating the Firmware

Use the following procedure to perform a firmware update on
the touchscreen controller.
1. Move the Power I/O (on/off) switch to the I (on) position.
• The unit will turn on and the touchscreen controller will
energize and show the Home Screen.
2. Touch the key.
• Enter the password [2 4 8]
using the number keys that
appear.
• The Service screen will
appear on the display.
3. Touch the firmware key on the
Service screen to access the
Firmware Update screen.
4. Insert the USB drive into the
USB port next to the controller,
and touch the UPDATE key on
the Firmware Update screen.
• The update will begin. When
complete, the touchscreen
controller will restart and
show the Home Screen.
8
English
Service
Firmware Usage
Control Timers
Testmode
Firmware Update
Plug-in the USB stick, then
press the Update button.
Update
Form No. HDWTCM-0121