Troubleshooting - EGO CS1610 Guide D'utilisation

TROUBLESHOOTING

PROBLEM
Motor does not
run.
Chain saw stops
running during
operation
Motor runs, but
chain does not
rotate.
Chain brake does
not engage.
46
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1610/CS1610-FC
CAUSE
◾
The battery pack is not
attached to the chain saw.
◾
There is no electrical contact
between the saw and battery.
◾
The battery pack is depleted.
◾
The battery pack or chain
saw is too hot.
◾
Chain brake is engaged.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
The chain saw is overloaded
◾
The battery pack or chain
saw is too hot.
◾
Saw chain is bound in the
wood.
◾
Chain does not engage drive
sprocket.
◾
Debris preventing full
movement of the chain
kickback brake handle.
◾
Possible chain brake
malfunction.
SOLUTION
◾
Attach the battery pack to the chain
saw.
◾
Remove the battery, check contacts
and reinstall the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or chain saw
to cool until the temperature drops
below 152°F (67°C).
◾
Pull the chain kickback brake handle
backward toward the front handle.
◾
Press the saw chain against the
wood, move the chain saw back and
forth to discharge the debris.
◾
Remove battery pack, then remove
side cover and clean out debris.
◾
Decrease the load
◾
Allow the battery pack or chain saw
to cool until the temperature drops
below 152°F (67°C).
◾
Release the variable-speed trigger
switch; remove the saw chain and
guide bar from the wood, then
restart the chain saw.
◾
Reinstall the chain, following the
chapter "REPLACING THE BAR
AND CHAIN". Ensure that the drive
links on the chain are fully seated
on the sprocket.
◾
Clean debris from the external chain
brake mechanism.
◾
Contact EGO Customer Service for
repair.