EGO CS1610 Guide D'utilisation page 42

7. Perform a few firm strokes on every
tooth. File all left-hand cutters in
one direction. Then move to the
other side and file the right-hand
cutters in the opposite direction.
Occasionally remove filings from the
file with a wire brush (Fig. 32).
WARNING:
sharpened chain can cause excessive
motor speed during cutting, which may
result in severe motor damage.
WARNING:
WARNING:
Top Plate Sharpening
Angles (Fig. 33)
◾
CORRECT 30° – This optimal angle
can be obtained only when the
specified files and proper setting
are used. File holders are marked
with guide marks to align the file
properly to produce the correct top
plate angle.
◾
LESS THAN 30° – The tooth is too dull for cutting.
◾
MORE THAN 30° – The edge of the cutting tooth is feathered and dulls quickly.
42
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1610/CS1610-FC
A dull or improperly
Improper chain sharpening increases the potential of kickback.
Failure to replace or repair a damaged chain can cause serious injury.
32
Left Hand
Cutters
33
Top Plate Sharpening Angles
LESS THAN 30°
30°
CORRECT INCORRECT
Right Hand
Cutters
MORE THAN 30°
INCORRECT