Troubleshooting - EGO CS1800 Guide D'utilisation

TROUBLESHOOTING

PROBLEM
Motor does not
start.
Chain saw stops
running during
working.
Motor runs, but
chain does not
rotate.
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1800/CS1800-FC
CAUSE
◾
The battery pack is not
attached to the chain
saw.
◾
No electrical contact
between the saw and
battery.
◾
The battery pack is
depleted.
◾
The battery pack or
chain saw is too hot.
◾
Chain brake is engaged.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
The chain saw is
overloaded.
◾
The battery pack or
chain saw is too hot.
◾
Saw chain is bound in
the wood.
◾
Chain does not engage
drive sprocket.
SOLUTION
◾
Attach the battery pack to the chain saw.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or chain saw to
cool until the temperature drops below
152°F (67°C).
◾
Pull the chain-kickback brake handle
backward toward the front handle, arriving
at the operating position.
◾
Press the saw chain against the wood,
move the chain saw back and forth to
discharge the debris.
◾
Remove battery pack, then remove side
cover and clean out debris.
◾
Decrease the load.
◾
Allow the battery pack or chain saw to
cool until the temperature drops below
152°F (67°C).
◾
Release the trigger switch; remove the
saw chain and guide bar from the wood,
then restart the chain saw.
◾
Reinstall the chain, following the section
"REPLACING THE BAR AND CHAIN".
ensuring that the drive links on the chain
are fully seated onto the sprocket.
45