Intial Set-Up; Smartdrive Pairing; Power Assist Activated - Permobil SmartDrive MX2+ Mode D'emploi

SmartDrive MX2+ | PushTracker E2 5

Intial Set-Up

After powering on, follow the prompts closely on the PushTracker E2. If any serious
difficulties are experienced during set-up, go to the Permobil [SmartDrive] / Max Mobility
website for more information and support.
Manual setting of the time, time zone and preferred format is required, and this is done in
the separate Settings app. After opening that app, enter the System menu to then access
the "Date & time" submenu. To manually set these, toggle OFF the "Automatic" options
then configure each to the correct and / or preferred values.
Upon successful completion, open the SmartDrive MX2+ app on the PushTracker
E2, either from the app list or from the button on the selectable SmartDrive MX2+
watchface.
SmartDrive MX2+

SmartDrive Pairing

Initial pairing of the PushTracker E2 to a SmartDrive is required, and this is done in the
SmartDrive MX2+ app. If the SmartDrive MX2+ app has not been previously paired to a
SmartDrive, turning power assist ON will initiate the pairing. If the SmartDrive MX2+
app has been previously paired to a SmartDrive, pairing can be done in the Settings menu
on the app.

Power Assist Activated

After successful pairing, power assist is turned ON and the SmartDrive MX2+ app
is connected to the SmartDrive, the Indication will flash blue. When the SmartDrive
motor is driving, the Indication will be solid blue. The Indication will flash red when