Activation And Service Functions - Olimpia splendid SHERPA Serie Instructions Pour L'installation, L'emploi Et L'entretien

Parameter
HEATING SET-POINT
DOMESTIC WATER
COOLING CLIMATE
CURVE ACTIVATION/
DEACTIVATION
deactivated
activated
HEATING CLIMATE
CURVE ACTIVATION/
DEACTIVATION
deactivated
activated
3.4

ACTIVATION AND SERVICE FUNCTIONS

To activate the unit, proceed as follows:
is activated. The operating mode is then displayed: CLG for cooling mode, HTG for heating and San for domestic water
production.
LED 2 lights up
The units are equipped with additional 2-stage heater elements: 1.5 kW + 1.5 kW on SMALL internal units and 3 kW + 3 kW
on LARGE units.
To enable this function, the outside air temperature probe kit must be installed. They can be enabled to supplement the power
temperature and the number of minutes set in parameter EhP after these conditions occur. The second element will activate
and 60 minutes in parameter EhP.
The electrical heater elements will activate even in the event of a fault on the external unit.
DISPLAY MENU
MNEMONIC
Temperature/
Set
HS2
User
Temperature/
Set
HS3
User
Ccc User
Hcc User
on the user interface to switch on yellow LED 1
, then heating and red LED 3
Range of Factory
setting
Factory settings for radiant
- 55°C
- 60°C
20-55°C 50°C
control is performed with set-
point cS1 or cS2
0, 1 0
control is performed in
accordance with climate curve
control is performed with set-
point HS1 or HS2
0, 1 0
control is performed in
accordance with climate curve
and green LED which shows the circulation pump
cooling mode is activated and the green
is on, Eco mode is active.
3
COMMENTS
51