User Menu; Setting The User Menu Parameters - Olimpia splendid SHERPA Serie Instructions Pour L'installation, L'emploi Et L'entretien

To view the above temperatures/set-points, proceed as follows:
3.2.3

User menu

TIMER
With this function the system can be set to switch on and off once a day.
NIGHT-TIME MODE
System yield and noise are limited in night-time mode.
COOLING SET-POINT
The thermostat can be set for two different water cooling temperatures, using parameters CS1 and CS2.
Temperature CS2 is used by activating Eco mode in cooling.
The thermostat can be set for two different water heating temperatures, using parameters HS1 and HS2.
Temperature HS2 is used by activating Eco mode in heating.
The thermostat can be set for one water heating temperature, using parameter HS3.
To optimise energy saving, two climate curves are available: one for heating and one for cooling. This function enables the
water temperature to be adjusted to the outside air temperature and therefore to the heating load, optimising system energy
saving.
The climate curves must be set on the system by authorised personnel, modifying certain parameters in the service menu.
with set-points Hs1 and Hs2.
with set-points Cs1 and Cs2.
3.3

SETTING THE USER MENU PARAMETERS

, press
Press menu to exit and the arrows to select another parameter.
Proceed in the same way for the other parameters.
simultaneously.
, to view t1 on the display
, to view the other mnemonic symbols on the display
, to view the measured temperature/set-point value
to quit temperature/set mode
to access the user menu, pressing it displays Usr for User.
3
and
49