Rear Shock - LMX Bikes ELECTRIC FREERIDE LMX 64 Manuel Utilisateur

4. On the LMX 64H, you must first unscrew the M6 screw from the licence
plate support before removing the axle from the rear wheel. Use a 5 mm
allen key for this.
5. For assembly: perform the operations in reverse order.
6.

REAR SHOCK

A. Hydraulic adjustment : Compression
Adjustments are
cartridge by simply turning the knob
marked with a blue "C".
There are 15 adjustment steps.
Hydraulic adjustment
Number of
clicks
When adjusting, it is best to turn the button until the soft stop
and then adjust the desired position. The factory setting is 3
notches from the "soft" stop (fully unscrewed thumbwheel).
made over the air
HARD
0 - 5
MEDIUM
5 - 10
SOFT
10 - 15
16