Checklist - LMX Bikes ELECTRIC FREERIDE LMX 64 Manuel Utilisateur

To install the battery on the frame, slide it back into the U-channel of the frame
and be sure to do so when the battery is completely at the bottom. A click indicates
that the battery is locked in place.
Be sure to close the rubber cap of the charging port before using the LMX.
To remove the battery, turn the key then slide the battery forward. Then remove the
key and then remove the battery completely by rotating it along its axis to the left
of the LMX.
The voltage of the battery gives an indication of the battery charge level:
100%
58 V
Lifetime
After 300 to 500 full charge cycles, the battery will provide 70% of its original
capacity. This number of cycles will be strongly influenced by the use case, the
driving style and the storage temperature.
Storage
For quality storage, it is advisable to store the battery in a dry and temperate place
(between 10 and 30 ° C).
Below 10 ° C, the useful capacity of the battery can be reduced by 30%.
In the event of a long period of non-use, it is advisable to store it in the state of
charge at 2/3 of its capacity. This corresponds to a no-load voltage of 52 V.
Maintenance
It is advisable to carry out a 24-hour maintenance charge every 5 cycles to ensure
cell balancing and optimal battery performance.
Note : The battery must not (or cannot) lose the charge level when not in use.
2.

CHECKLIST

Before using the LMX, check the following :
➔ The battery must be charged and locked to the frame.
➔ All the screws and nuts should be tightened and locked. Use medium
thread lock if necessary.
➔ The wheels, suspension and handlebars and the stem must have no play
and be tight.
➔ The saddle should be tight.
80%
56 V
50%
52 V
20%
46 V
0%
42 V
7