Napoleon GDS28N Instructions D'installation Et D'opération page 30

30
PHAZER logs, glowing embers and charcoal embers exclusive to Wolf Steel Ltd. fireplaces, glow when exposed
TM
to direct flame and provide a unique and realistic glowing effect that is different in every installation. Use only certi-
fied PHAZER
TM
EN
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour pig-
ments burn in during the heat activated curing process.
Place the back log (1) into the firebox, pushing it as
A.
close to the firebox wall as possible and centered
onto the log support pan.
Place the front log (2) on the ember screen lining up
B.
the studs with the holes on the bottom of the log.
NOTE: Ensure the left support tab and the two
right support tabs are bent down to ensure the front
burner flame does not get sucked
beneath the front log.
Set the two cross-over logs (3, 4)into
C.
the pockets provided on both the front
and rear logs as shown.
NOTE: The ember screen frame has a minimal adjustment distance.
However, when heating with propane, ensure the ember screen is secured as close to the rear of the
firebox as possible (figure 1). This will ensure the log's distance from the flames, and prevent excess
carbon and soot.
When heating with natural gas, ensure the ember screen is secured as close to the glass door as
possible (figure 2). This will ensure the log's placement over the flames, and create a glowing effect on
the log.
PROPANE
W415-1426 / C / 07.31.18
logs, glowing embers and charcoal embers available from your local authorized dealer / distributor.
Figure 1
1
1
2
2
4
2
4
4
NATURAL GAS
3
3
3
Figure 2