Toshiba MiNi-SMMS MMU-AP0071MH Manuel Du Propriétaire page 18

Floor Standing Type
Adjustment of air flow direction upwards/downwards
[In Cooling operation]
In cooling operation, move the flap with your hands so that the horizontal
air outlet points in a direction so that the cold air diffuses the entire room.
[In Heating operation (For Heat-pump model only)]
In heating operation, move the flap with your hands so that the horizontal
air outlet points in a downward direction, towards the floor.
Adjustment of air flow direction rightwards/leftwards
[In case of using unsymmetrical air directions]
Lift up the vertical flap lightly and direct it towards the desired
direction. Once completed lower the flap back down.
In this case, do not use the Swing function.
[In case of automatic swing]
1
SWING/FIX
Push the button during operation.
• [SWING ] is displayed and the air direc-
tion will automatically change rightwards/
leftwards.
In cases where one remote controller con-
trols multiple indoor units, it is possible to
set each indoor unit individually, so that the
air flow direction can be altered.
2
SWING/FIX
Push the button again while the
vertical flap is moving will allow you to
stop the louver in the desired position.
3
UNIT
Swing button
• To set up the air flow direction individually,
UNIT
push the button to display each indoor
unit No. in a group control. Then set up the
air flow direction to the desired indoor unit.
• If there is no display, all the indoor units can
be operated collectively.
• Every push of the
the display as shown in the figure.
• If cooling operation is performed with downward air outlet, dew may form on the surface of the cabinet or
the horizontal flap, resulting in possible dripping of water.
• If heating operation is performed with the horizontal air outlet actively moving, unevenness of the tem-
perature may increase in the room.
• Do not move the flap directly with your hands during swing operation; otherwise a fault may be caused.
The vertical flap does not stop immediately even if the
SWING/FIX
tion, push the
UNIT
button, will change
INFORMATION
button.
2
1
In this case, do not use the
swing function.
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL
1, 2
No display
Unit No. 1-4
SWING/FIX
button is pushed. To adjust the stop posi-
15
ON / OFF
FAN MODE
SWING/FIX VENT
UNIT
3
Unit No. 1-1 Unit No. 1-2
Unit No. 1-3