Publicité
Les langues disponibles
Les langues disponibles
Ford Focus Clipper
2004 - ....
Ref. 1502
Fitting instructions
1)
Disassemble the bumper and permanently remove the synthetic buffer beam.
2)
Insert supporting arms (1) and (2) in the chassis beams through the openings at the back of the vehicle.
The points (A) match the provided drillings in the side of the chassis beam. Insert the bolts and the plates
(3) but do not tighten.
3)
Place the tow bar with points (B) between the already assembled supporting arms, insert the bolts and
tighten everything firmly (see tension).
4)
Make an incision at the bottom of the bumper according to drawing. Re-assemble the bumper on the
vehicle. Attention: Facelift !!! Construction year 2004 – 2007 ≠ of Construction year >2008
5)
Assemble the ball T45 of the pedestal of the removable system T36 together with the socket plate and the
security shackle, insert the bolts and tighten everything firmly (see tension).
Disassemblage of the bumper
-
2 small screws at the entrance of the trunk
-
2 plastic plugs at the bottom of the bumper
-
2x2 small screws on the splash-boards
-
2x1 small screw M6 behind the splash-boards
Composition
Tow bar reference 1502
1 ball T45K000
4 security nuts M12 - DIN985
4 bolts M12x70 - DIN931
1 security shackle 800053
2 pieces T45
2 tubes T45
1 socket plate holder (P04)
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
4 bolts DIN931 - M10x43
(*-*')
4 rings DIN128 - A10
(*')
4 bolts DIN931 - M12x45
4 nuts DIN934 - M12
(*')
4 rings DIN128 - A12
(*-*')
2 plates (3)
(*-*')
2 supporting arms, left (1) and right (2)
(*)
All bolts and nuts : quality 8.8
(A)
(A)
(B)
(B)
(B)
(A)
(B)
Publicité
