Fireplace Xtrordinair 864 See Through GS2 Manuel D'installation page 11

Supports de clouage
There are eight nailing brackets on the front and back of the fireplace.
Bend the tabs out to position the nailing brackets. Once in place, nail or
screw the nailing brackets to the framing.
NOTE: Additional nailing brackets are
provided along the base of the
fireplace. Use these brackets if not
using the front brackets.
NOTE: The side standoffs have
obround holes that allow for the
standoff to be adjusted for drywall of
1/2" or 5/8".
NOTE: You may need to bend the
tabs out on one side then slide the
fireplace out to bend the tabs out on
the opposite side
© Travis Industries
Installation
(for qualified installers only)
TOP VIEW
Fireplace
1/18/2019 – 1404-FR
Framing
Nailing Bracket
Drywall
11
WARNING: Make sure the
fireplace is square and plumb
when placed in the framing.
Measured corner-to-corner, the
fireplace should be square
(approx. 54-7/8"or 1394mm for
each dimension). Use shims to
insure the fireplace is square.
864 GS2 ST